Air King Ventilation Hood Exhaust Fan with Light User Manual

0

Out of 0 Ratings

Owner's of the Air King Ventilation Hood Exhaust Fan with Light gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 12
 
the wall switch to both the red wire from the fan’s light
receptacle and the black wire from the fan’s exhaust
receptacle. Connect the ground wire from the house to the
green wire from the fan’s grounding screw (Figure 10). Use
approved methods for all connections.
4. Carefully tuck wire back inside wire compartment and replace
wire compartment cover securing with the screw that was
removed earlier.
SECTION 6
Completing the Installation
1. If the fan’s blower assembly was removed during the wiring
process, reinstall the blower by reversing the directions in
Step 1b
in Section 5
Wiring
.
2. Insert the fan’s plug into the receptacle (Figure 7).
3. Remove glass light lens from grill by unscrewing knob at the
top of lens (Figure 11).
4. Plug cord from lamp holders into the appropriate receptacle
(Figure 12).
5. Line up slots in the grill with lances on inside of housing. Insert
included #8 screws through grill slots and into housing lances.
Tighten both screws until the grill fits snugly to the ceiling. DO
NOT OVER TIGHTEN (Figure 13).
www.airkinglimited.com
210572200 Rev. A 6-06 4 of 12
CAUTION: FAILURE TO SECURE THE GRILL MAY RESULT
IN A RATTLING OR HUMMING NOISE.
6. Install 2 - 60 watt maximum, type A19 medium base
incandescent bulbs (not included).
7. Reinstall the glass lens in place by sliding the hole in the
lens onto the rod from the grill and securing in place with
the lens knob removed in
step 3
(Figure 14).
8. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Refer to instructions in Section 6
Completing the Installation
, to remove grill and glass light
lens. Use a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR
SCOURING POWDERS. Completely dry all parts before
reinstalling. Refer to instructions in Section 6
Completing the
Installation
, to reinstall grill and glass light lens.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth
or gently vacuum the fan. NEVER IMMERSE ELECTRICAL
PARTS IN WATER.
CAUTION: ALLOW BULB TO COOL BEFORE REPLACING.
Figure 14
Grill
Glass Lens
Knob
Hole
Rod
Grill
Lances
#8 Screws
Figure 13
Figure 12
Cord
Lamp
Holders
Figure 10
Ground
Hot (Red)
Supply
from
house
White
Figure 11
Knob
Glass Lens
Hot (Black)

   Find Your Products By Category