0

Out of 0 Ratings

Owner's of the Air King Ventilation Hood Exhaust Fan with Light gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 12
 
2. Wiring Fan/Light together: Run wiring from an approved wall
switch carrying the appropriate rating. One neutral (white),
one ground (green or bare copper), and one hot (black lead
connected to the switch). Secure the electrical wires to the
housing with an approved electrical connector. Make sure
you leave enough wiring in the box to make the connection
to the fan’s receptacle.
2a. From where you have access to inside the fan’s junction
box, connect the one white wire from the house to both the
white wire from the fan’s light receptacle and the white
wire from the fan’s exhaust receptacle. Connect the black
wire from the wall switch to both the black wire from the
fan’s light receptacle and the black wire from the fan’s
exhaust receptacle. Connect the ground wire from the house
to the green wire from the fan’s grounding screw (Figure
9). Use approved methods for all connections.
SECTION 6
Completing the Installation
1. Reinstall the fan’s venturi by holding it at approximately a 45
degree angle, hook the two tabs on the venturi into the slots
on the housing and secure in place by tightening the venturi
screw. Rotate the blower wheel by hand to ensure it spins
freely. Now plug the fan motor into the receptacle (Figure 10).
2. Remove glass light lens from grill by unscrewing knob at the
top of lens (Figure 11).
SECTION 4
Ducting
CAUTION: ALL DUCTING MUST COMPLY WITH LOCAL
AND NATIONAL BUILDING CODES.
1. Connect the ducting to the fan’s duct collar (Figure 7). Secure
in place using tape or screw clamp. Always duct the fan to
the outside through a wall or roof cap.
NOTE: If damper detaches from unit, reattach by snapping the
collar back onto the unit. It is designed to only fit one way.
SECTION 5
Wiring
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE
MADE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES,
OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR
WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE
THE SERVICES OF A QUALIFIED ELECTRICIAN.
1. Wiring Fan/Light Independently: Run wiring from an approved
wall switch carrying the appropriate rating. One neutral (white),
one ground (green or bare copper), and two hot (black lead
connected to the switch). Secure the electrical wires to the
housing with an approved electrical connector. Make sure
you leave enough wiring in the box to make the connection to
the fan’s receptacle.
1a. From where you have access to inside the fan’s junction box,
connect the one white wire from the house to both the white
wire from the fan’s light receptacle and the white wire from
the fan’s exhaust receptacle. Connect the first black wire from
the wall switch to the black wire from the fan’s light receptacle.
Connect the second black wire from the house to the fan’s
exhaust receptacle. Connect the ground wire from the house
to the green wire from the fan’s grounding screw (Figure 8).
Use approved methods for all connections.
Figure 8
Ground
Hot (Black)
Supply
from
house
White
Figure 10
www.airkinglimited.com
210572063 Rev. A 8-05 3 of 12
Figure 6
Figure 7
Figure 9
Ground
Hot (Black)
Supply
from
house
White