Bissell Vacuum Cleaner SPOTBOT User Manual

2.0

Out of 1 Ratings

Owner's of the Bissell Vacuum Cleaner SPOTBOT gave it a score of 2.0 out of 5. Here's how the scores stacked up:

  • Reliability

    1.0 out of 5

  • Durability

    1.0 out of 5

  • Maintenance

    1.0 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    3.0 out of 5
of 16
 
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Operations
10
Manual cleaning
1. Remove the hose from the unit by
depressing the release button.
2. A
. Remove the Tough Stain Brush from
the back of the unit.
B. Attach the Tough Stain Brush onto the
grip of the hose.
3. Select the hose button on the
control panel to start the SpotBot.
NOTE: In manual mode, the SpotBot
will not turn on until the hose is discon-
nected from the hose connector. If it
is not removed within 30 seconds of
pushing the hose button, the unit will
shut off.
4. Begin cleaning by holding the tool no
more than six inches above the soiled
surface. Depress the spray trigger for
about 5 seconds to apply the cleaning
solution to the soiled area. Release the
trigger. Be careful not to overwet.
5. Using the brush on the tool, gently scrub
the soiled area until it appears to be
clean.
6. To suction up the dirt and cleaning solu-
tion, position the suction nozzle over the
cleaned area, apply downward pressure
on the tool, and pull nozzle toward you.
You should see the dirty solution pass
through the nozzle. Continue until no
more solution can be removed.
NOTE: In manual mode, the SpotBot is
equipped with a safety feature which
will shut the unit off after 30 minutes.
Press start to resume cleaning.
7. If the stain is still visible, repeat steps
4-6 as necessary.
8. When the cleaning is complete, lightly
drag the suction nozzle across the stain
to further aid in drying the cleaned
area.
9. Before turning off the SpotBot, suction
up clean water to thoroughly rinse out
the inside of the vacuum flex hose.
Then, lift the vacuum flex hose upwards
to drain any remaining water into the
dirty tank.
1.
2A. 2B.
3.
Tip:
One of the effective stain removing
ingredients in Oxy Gen2 is Hydrogen
Peroxide. Certain people may be
affected by the product when it comes
into contact with their skin; it may turn
the skin white and/or cause tingling.
Washing your hands after use and
applying hand lotion will remove any
possible white discoloration.
Tip:
Check upholstery stuffing before
cleaning. Colored stuffing may
bleed through the fabric when it
becomes wet.

   Find Your Products By Category