0

Out of 0 Ratings

Owner's of the Closet Maid Indoor Furnishings 6620 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 1
 
6620
Bracket Chart
Needed pieces
Shelf Length
4’
1. 2m
6’
1. 8m
8’
2.4m
12’
3.7m
Wall toWall
Pared apared 2222
Wall to Open
Pared a borde 1111
Open to Open
Borde a borde 0000
1
Place side wall bracket over front of shelf and against wall as shown. Rotate shelf
up and into position. Place a level onto shelf. Raise or lower shelf until shelf is
level. Be sure side wall bracket is straight on front lip of shelf and use a pencil to
mark hole locations. Set aside wall bracket and allow shelf to hang down. Drill
1/4" holes at marked locations. DO NOT PUNCH HOLES.
Coloque el soporte para pared al frente de la repisa y contra la pared como se
muestra. Gire la repisa hacia arriba para que quede en posición. Coloque un
nivelador sobre la repisa. Eleve o baje la repisa hasta nivelarla. Asegúrese que el
soporte de pared quede alineado con el borde frontal de la repisa y utilice un lápiz
para marcar las ubicaciones de los orificios. Reserve los soportes para instalarlos
después y permita que la repisa quede colgando. Perfore orificios de 6 mm en las
ubicaciones marcadas. USE TALADRO UNICAMENTE.
2
Replace wall bracket on front lip of shelf and raise to align with holes. Place
preloaded anchor through bracket and into holes in wall. Use bottom of
hammer handle to push in pins. To remove, pry pins out with screwdriver.
Coloque los soportes para pared en el borde frontal de la repisa y elévelos
para alinearlos con los orificios. Coloque el tarugo precargado a través del
soporte y dentro de los orificios en la pared. Use la parte inferior del mango
del martillo para empujar las clavijas hacia adentro. Para remover,
palanquee las clavijas sacándolas con un destornillador.
Consumer Toll-Free Help Line
1-800-874-0008
(U.S.A andCanada)
www.closetmaid.com
Manufacturer reserves the right to
change specifications without notice.
MadeinUSA
©ClosetMaid Corporation 2004
Ocala, FL 34478-4400
75381 06620
04
01-84624
If a ClosetMaid® product does not give user
complete satisfaction when installed in
accordance with manufacturer's instruc
-
tions, it will be exchanged free of charge.
Only the unsatisfactory part in a multi-piece
product will be exchanged.